What are cost multipliers?

What are cost multipliers?

A cost multiplier shows what one dollar of cost becomes once the indirect rates are applied. It is a break-even, burdened figure. It contains no profit or fee. Profit and fee are added later, when you price a contract (see How do I test a cost-type contract price?).

The two kinds

  • Labor cost multiplier: the fully burdened cost of a labor dollar, meaning direct labor plus applied fringe, overhead and G&A, expressed as a single multiplier. It is shown per overhead pool.
  • Non-labor cost multiplier: what a materials, subcontract, travel or ODC dollar picks up.
    • Routed to MSOH: MSOH, then G&A on the MSOH amount.
    • In an overhead base: the pool's overhead, then G&A.
    • Anything else, or MSOH not used: G&A alone.

It can differ by overhead pool, so the Rate Summary lists it per pool.

Where to find them

Rates and cost multipliers are on Calculate & Reconcile. Since version 3.22.0, Pricing & Comparison covers contract pricing only. Pricing starts from these multipliers, so check them here first.

If this doesn't work: if the Rate Summary shows a red message, see Calculation is blocked: what data is missing?.

Watch: Pricing and cost multipliers, from 0:15

Full guide section: Glossary

Related: How do I read the Rate Summary? | How do I test a cost-type contract price? | Should I use an MSOH pool?