Should I use an MSOH pool?

Should I use an MSOH pool?

Use MSOH when you want to recover a handling cost on materials and subcontracts as its own rate. Choose Yes on the MSOH card to include it. Whether you should is a business and accounting decision; Rate Studio shows you the effect.

How MSOH works

  • The pool collects MSOH labor, expenses, applied fringe and applied intermediate cost. Its rate is the pool divided by the MSOH base.
  • Materials and subcontracts routed to MSOH are always in the MSOH base. Travel and other direct costs are optional, so check them only if a handling fee applies.
  • A cost routed to MSOH leaves the G&A base as raw dollars, and it cannot also sit in an overhead base.
  • G&A is calculated after MSOH and applies to the MSOH amount, not to the underlying materials.

The math

$100,000 of materials at a 5% MSOH rate gives $5,000 of MSOH. G&A at 24% applies to that $5,000, which adds $1,200, for a total burden of $6,200, a 6.2% effective rate. The two rates never compound. See Why MSOH math is additive, not compound.

If you turn MSOH on

Use the routing table to send costs to it (How do I route materials, subcontracts, travel and ODC?). If MSOH is on but nothing is routed to it, Rate Studio warns you, because the pool would have no base (MSOH is on but nothing is routed to it).

If a structure doesn't use MSOH

Costs recorded as MSOH, such as MSOH labor in a trial balance, default to G&A. You can treat them as overhead in one of that structure's pools instead. It is a structure decision, so it can differ between structures, and your cost data does not change.

If this doesn't work: see MSOH is on but nothing is routed to it.

Watch: MSOH and G&A, from 0:11

Full guide section: Configure Structures

Related: Why MSOH math is additive, not compound | How do I route materials, subcontracts, travel and ODC? | MSOH is on but nothing is routed to it