How do I set up overhead pools and their allocation bases?

How do I set up overhead pools and their allocation bases?

Choose the number of overhead pools, name each one, then pick each pool's allocation base. The base is the denominator of the overhead rate.

Steps

  1. On Configure Structures, open the Overhead card.
  2. Choose how many overhead pools this structure needs. One pool gives a single combined overhead rate. Use more when your work carries overhead differently, for example services and manufacturing, or SCA and non-SCA work. Your plan sets the maximum (see What are my plan limits? (tiers vs. editions)).
  3. Name each pool to match how you run the business.
  4. Choose each pool's allocation base:
    • Direct labor plus applied fringe is the most common.
    • Material dollars, or prime costs (direct labor plus materials), suit manufacturing.
    • Hours, machine hours and units of production need data from outside the general ledger, so Rate Studio flags them with a warning.
  5. If you have more than one fringe pool, choose which fringe pool applies to each overhead pool's labor.

What a pool collects

Each overhead pool collects overhead labor, overhead expenses, the applied fringe on that labor, and any intermediate pool cost allocated to it.

Bid and proposal (B&P) labor and IR&D labor, with their applied fringe, bear overhead like direct labor. Each of those dollars is tagged to the one overhead pool it bears cost from when you enter cost data, so it sits only in that pool's base.

Below each base is the routing table for materials, subcontracts, travel and other direct costs. See How do I route materials, subcontracts, travel and ODC?.

If this doesn't work: if Data Requirements shows red items after you add pools, see Calculation is blocked: what data is missing?.

Watch: Overhead pools and bases, from 0:14

Full guide section: Configure Structures

Related: How do I route materials, subcontracts, travel and ODC? | How do I set up fringe? | How are B&P and IR&D treated?